Ktag 2.13 Ktag firmware V7.003 Ktag KTM100 V2.13 No tokens limit
Ktag ktm100 V2.13 ktag firmware V7.003 Connection error E000079 Problem:
After well installed the obd2tuning.com Ktag KTM100 V2.13 software on Win XP laptop and tried to select ECU to read and write. The software displays no ECU options under “Option” tab (all options are in gray). Meanwhile, the KTM100 software reported an error:
“Initialization…
Interface connected…
Firmware Version: v7.3 build:0000
OBD2Tuning.com Ktag clone update Ktag ktm100 V2.13 ktag firmware V7.003 Connection error E000079 solution:
Possible causes:
1.Internet connection have not been disabled
2.Ktag driver is not well installed
3.There is no power supply fed to the Ktag ecu programmer
4.TF card and Shrapnel has poor connection
Solution:
1.Please disable internet/network connection before installing software. THIS IS VERY IMPORTANT!!!
2. Make sure obd2tuning.com Ktag KTM100 driver is well installed.
Open My Computer>>Manager>>Device Manager>>Universal Serial Bus controllers>>DimSport-New Trasdata Device to check the good communication between K-tag and computer.
3.Make sure there is a power supply fed to the Ktag ECU tuning kit.
4.If all the previous conditions are no problem, then the problem lies on the TF card. Make the shrapnel firmly attached to the TF card.
In our customer’s case, the TF card is loose connection. He higher the shrapnel to make it firmly attached to the TF card, then the problem was solved.
OBD2Tuning.com Focus on OBD Tool Since 2008
https://www.facebook.com/obd2tuning/
This article is compiled by www OBD2Tuning com, if you have any advice on it, pls feel free to contact OBD2Tuning - China OBD2 Tuning Tool Automotive Diagnostic Tools Car Key Programmer OBD2 ECU chip tuning tool Center.
沒有留言:
張貼留言